Heating and regulation of the fan both work. Thomas Am 09.09.2013 um 20:58 schrieb Marius Kintel <marius@kintel.net>:
On 2013-09-09, at 2:53 PM, Thomas Mieling <thomas@mieling.at> wrote:
I attached the signal-wires of the y-axis to the driver-board of the extruder.
Perfect. Did you manage to test any of the extruder controller functions (like heating), to further debug the issue, or does it appear as if the extruder controller simply doesn't communicate with the motherboard. I think that the motherboard will report the extruder controller version on startup on the serial port. Unfortunately, the protocol is binary so it's a bit tricky to debug without using RepG or MakerWare..
-Marius
_______________________________________________ Metalab mailing list Metalab@lists.metalab.at https://lists.metalab.at/mailman/listinfo/metalab