9 Sep
2013
9 Sep
'13
18:26
On 2013-09-09, at 2:19 PM, Thomas Mieling <thomas@mieling.at> wrote:
Das Problem scheint eher die Firmware (oder ReplicatorG) zu sein.
I would try upgrading the firmware. Note that there are two firmwares: One for the motherboard and one for the extruder controller. There should be a separate USB cable attached for firmware upgrade of the extruder controller (and marked as such). Makerbot actually supports Thing-o-matics in their new MakerWare software. I would recommend giving that a try: http://www.makerbot.com/support/thingomatic/documentation/makerware/ -Marius