I tried this today as well, but no success… Firmware version 3.1 (the latest) did not solve the problem, the i flashed an older version (before a change in the toolhead-protocol), but this did not change anything either. Thomas Am 09.09.2013 um 20:26 schrieb Marius Kintel <marius@kintel.net>:
On 2013-09-09, at 2:19 PM, Thomas Mieling <thomas@mieling.at> wrote:
Das Problem scheint eher die Firmware (oder ReplicatorG) zu sein.
I would try upgrading the firmware. Note that there are two firmwares: One for the motherboard and one for the extruder controller. There should be a separate USB cable attached for firmware upgrade of the extruder controller (and marked as such).
Makerbot actually supports Thing-o-matics in their new MakerWare software. I would recommend giving that a try: http://www.makerbot.com/support/thingomatic/documentation/makerware/
-Marius
_______________________________________________ Metalab mailing list Metalab@lists.metalab.at https://lists.metalab.at/mailman/listinfo/metalab